|
SOLTEK 75FRN SERIES CPU VOLT MOD
This mod is quite simple,
and quite effective! The board uses the HIP6302 voltage regulator
to control voltage. Double check your board to make sure you see
that on your chip. This particular mod will allow for up to ~2.25V
on the vcore when you set it to 1.85V in the bios. I could only
get it to 2.25 once, as I was aircooling at the time I did the mod.
With more serious cooling keeping a stable high voltage shouldn't be a
problem. I took a picture @ 2.11v below. You'll need a 25k
Ohm variable resistor for this mod, some wire, and whatever means you
are using to connect the mod to the board. Just solder it on, and
adjust to your liking!
|
